Publicidad
3. Lay the Top (A) face-down on a clean, protected surface. Align the leg assemblies and insert dowels
into the holes in the Top (A). Insert #8 x 1-1/4" Pan Head Screws (Ka) through the side assemblies
and into the Top. See Figure 3.
4. With the unit lying face-down, measure from the top left to bottom right and from the top right to
bottom left. If the unit is square, the measurements will be equal. If one measurement is longer, tap the
bottom of the longer side panel until the measurements are equal. Place the Back (F) on the grooved
area in the Top and Back Legs. Attach Back (F) using #6x5/8" Philtruss Screws (La) through the
predrilled holes and into each side assembly and upper and lower sleepers. See Figure 4.
Page 4 — 631Wa — 12/13
Fig. 3
La
Fig. 4
Ka
Ka
A
La
F
Publicidad
