Jam HX-EP410A Libro De Instrucciones página 3

SET UP
CHARGING YOUR EARBUDS
To charge your earbuds, place them into the
portable case. The red LEDs show that they are
charging. If the red LEDs do not appear when
placed in the case, adjust the earbuds to make
sure they are in line with the charging contacts.
When fully charged, the LEDs will shut off.
CONNECT BOTH EARBUDS
STEP 1 – TURNING ON THE EARBUDS
Your earbuds will automatically turn on when
taken out of the portable charging case. If you
need to turn them on manually, you can press
and hold the play/pause button on both earbuds
for 3 seconds.
STEP 2 – CONNECTING THE EARBUDS TO
EACH OTHER
When you take the earbuds out of their case,
they will automatically sync to each other. The
master earbud (left) LED will flash blue and red
alternatively, while the slave earbud (right) LED
will slow flash blue. Your earbuds are now in
pairing mode and searching for a Bluetooth
device to connect to.
EN
3s
®
CHARGING YOUR PORTABLE CASE
Plug the small end of the micro USB cable into
the micro USB port, located on the back of the
case. The LED on the case will show solid red
when charging. When the portable case is fully
charged, the LED lights will turn off.
If your earbuds don't sync to each other
automatically, double press the "play/pause" button
on both earbuds at the same time. This will put
your earbuds into sync mode. Once connected, the
left earbud LED will flash blue and red alternatively,
while the right earbud LED will slow flash blue. Your
earbuds are now in pairing mode and searching for
a Bluetooth device to connect to.
®
2x
3