IPC ML.Compact Serie Manual De Instrucciones página 22

- This fundamental safety requirement must
be verified. If in doubt have the electrical in-
stallation checked by a qualified electrician.
An unearthed electrical installation absolves
the Manufacturer of all liability for damage.
- The high pressure washer must be con-
nected to the mains electricity supply by me-
ans of an omnipolar switch with a minimum
contact opening of 3 mm and electrical cha-
racteristics suitable for the appliance (this
requisite is not applicable to high pressure
washers with a plug and a power rating of
less than 3kW).
It is recommended that the electric supply
to this machine should include a residual
current device that will interrupt the supply
if the leakage current to earth exceeds 30
mA for 30 ms or a device that will prove the
earth circuit.
- The high pressure washer is disconnected
from the mains electricity supply only when
unplugged from the mains socket or when
the omnipolar switch in the mains installation
is turned off.
Failure to respect the above absolves the
Manufacturer of all liability and represents
negligent use of the product.
- The high pressure washer is considered as
a permanently installed appliance.
- High pressure washers with Total Stop
device are considered off when the omni-
polar switch is in the "0" position and when
unplugged from the mains socket.
- The high pressure washer is not intended
for use by children, adolescents or persons
with reduced physical, sensory or mental
capabilities, under the influence of alcohol
or lacking experience and knowledge.
Children must be supervised to ensure they
do not play with the high pressure washer.
English
- Water passing through a system separator
is no longer classified as drinking water.
Use a suitable EN 12729 type BA system
separator.
- Use exclusively original accessories offe-
ring a guarantee of safe operation.
- The hose connecting the lance to the high
pressure washer must not be damaged.
If it is damaged, replace it immediately.
- The hose must be marked with the per-
mitted pressure, date of fabrication and
manufacturer.
- High pressure hoses, fittings and couplings
are important for the safety of the high
pressure washer. Use original spare parts
approved by the Manufacturer only.
- Do not use the high pressure washer if
there are people and/or animals within its
operating range.
- High pressure jets may be dangerous if
not used correctly. The jet must never be
directed at people and/or animals, electrical
appliances or the high pressure washer
itself.
- The water jet generates recoil on the lance.
Hold the lance handgrip firmly.
- Use of the high pressure washer must be
assessed according to the type of washing to
be done. Take precautions against the expul-
sion of solid material or corrosive substances
by using suitable protective garments.
- 18 -