PNI JOPIX AN-2 Manual De Instrucciones página 34

4. Press channel selector knob or [FUNC] key to store setting and exit.
5.16.- ROGER BEEP FUNCTION (BEEP):
1. Press [FUNC] key to choose programmed function group.
2. Press the programmable key which allocated as RB function, LCD displays RB: XX.
3. Press it again or turn channel selector knob to choose RB group.
4. Press channel selector knob or [FUNC] key to store setting and exit.
5.17.- HI-CUT FUNCTION (HIC):
1. Press [FUNC] key to choose programmed function group.
2. Press the programmable key which allocated as HIC function, LCD displays HIC:
XX.
3. Press it again or turn channel selector knob to switch between ON
4. Press channel selector knob or [FUNC] key to store setting and exit.
5.18.- CTCSS/DCS CODES (TSQ) (optional):
1. Press [FUNC] key to choose programmed function group.
2. Repeatedly press the programmable key which allocated as TSQ function, LCD
displays TSQ: XX.
Note:
- Refer CTCSS/DCS table for details.
3. Press it again or turn channel selector knob to switch between ON
4. Press channel selector knob or [FUNC] key to store setting and exit.
Note:
- This function is available only when install optional CTCSS/DCS board into
transceiver.
6.- SETTINGS MENU:
How to enter function menu:
1. Press and hold [FUNC] key to enter settings menu.
2. Press [F4], [F6] key or turn the channel selector knob to move cursor and choose menu.
Press [F5] key will fast turn menu page.
3. Press channel selector knob to enter the setting.
4. Press the [P4], [P6] key or turn the channel selector knob to move cursor and set the
function.
6.1.- BEEP SOUND (BEEP):
1. Enter settings menu and choose NO.1 function menu.
2. Press channel selector knob to enter function setting, the chosen value in LCD will
turn to green color.
3. Turn channel selector knob to choose wanted setting.
4. Press channel selector knob or [F3] key to confirm and exit.
English - 10 -
OFF.
OFF.