PNI JOPIX AN-2 Manual De Instrucciones página 45

14.- TROUBLESHOOTING:
PROBLEM
- The transceiver do
not power ON when
operate
[ON/OFF/Mute] key.
- The transceiver
doesn´t transmit or
the transmission is
poor quality.
- The transceiver
doesn't receive or the
reception is poor
quality.
- In the
communication the
other user disappears
or interferences
appear.
If continues the transceiver problems, consult with their salesperson or Technical
Service.
- Check the fuse and replace it if is necessary with another of its
same characteristics, first verify the CB transceiver connections if
there are some shortcircuit.
- Check that the DC power cable is connected correctly, red cable
(+) and black cable (-).
- Check the SWR of the antenna.
- Verify that the antenna is connected properly.
- Verify that the microphone is connected correctly.
- Press and hold the [PTT] of the microphone and speak into the
microphone with a normal and clear voice tone.
- Check that we use the same modulation type as the other CB
transceivers.
- Make sure you have selected a channel where there is a
communication.
- Check that the squelch setting is properly.
- Check that the volume level is correctly.
- Verify that the antenna is connected properly.
- Check the SWR of the antenna.
- Check that we use the same modulation type as the other CB
transceivers.
- Verify the programmed CTCSS/DCS codes.
You or the other user is in areas of poor RF signals
communications (e.g.: indoor a tunnel, among mountains, next to
high power voltage lines, etc.).
English - 21 -
POSSIBLE SOLUTION