Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
POUNT$
PROBLEM
Does not start
Loss of power
i
i i
_l,i
Poor cut - uneven
Excessive
vibration
,m
i
Starter rope hard to pufl
Loss of drive
. ii,i. i
Grass catcher not filling
(if so equipped)
Hard to push
CAUSE
I
2
3
4
Dirty air filter
Out of fuel
Staie fuel
Water in rue!
5
Spark plug wire is disconnected
6
Bad spark plug
7
Loose blade or broken blade adapter
8,
Controt bar in released position
9
Control bar defective
1
Rear of lawn mower housing/blade_ dragging
In heavy grass
2_ Cutting too much grass
3
Dirty air filter
4
Buildup of grass, leaves and trash under mower
5
Too much otl tn engine
6
Walking speed too fast
1
Worn, bent or loose blade
2
Wheel heights uneven
3.
Low engine speed
4
Buildup of grass, leaves, and trash under mower
1
Worn, bent or loose blade.
2
Bent engine crankshaft
1
Engine flywheel brake is on when control bar is
released,
2
Bent engine crankshaft
3
Blade adapter broken
4
Blade dragging In grass
I
Drive wheels not turning with ddve control engaged,
2
Belt not ddving
,r
1
Cutting height too low
2,
Lift on blade worn off.
3.
Catcher not venting air
4
Low engine speed
1
Grass is too high or wheel height is too low
2.
Rear of lawn mower housing/blade dragging
in grass
3
Grass catcher too fufi
4
Handle height position not right for you
CORRECTION
1
Clean/replace air filter
2
Fill fuel tank
3
Drain tank and refill with fresh clean fuel
4
Drain fuel tank and carburetorand
refill tank with fresh
gasoline,
5
Connect wire to plug
6
Replace spark plug
7
Tighten blade bolt or replace biade adapter
8o Depress control bar to handle
9
Replace control bar
1.
Set in "Higher Cut" position,
2
Set in =Higher Cut" position
3
Clean/replace air filter
4
Ctean underside of mower housing
5
Check oil level
6
Cut at slower walking speed
1
Replace blade. Tighten blade bolt
2
Set aJl wheels at same height
3
Set engine speed control in fast position
4
Clean underside of mower housing.
1
2
1
2,
3.
4
Replace blade, Tighten blade bolt
Contact authorized service center!department
Depress control bar to upper handie before
pulling starter rope
Contact authorized service center/department
Replace blade adapter
Move lawn mower to cut grass or to hard surface
to start engine
1,
Adjust or replace drive control cab{e, if broken
2
Put belt on pulEeysor reptace botts if broken
Io
Raise cutting height
2
Replace blade
3
Cleangrass
catcher.
4
Set engine speed control in fast posilion
l r
Raise cutting height
2
Raise rear of lawn mower housing one (1)
setting higher
3
Empty grass catcher
4,
Adjust handle height to suit
19
Publicidad
