Worx AXIS WX550 Manual Original página 12

Cutting
WARNING!
• Never hold the pivot head
when operating the tool.
• Never hold the motor cover when
operating the tool.
Always use a blade suited to the
material and material thickness
to be cut. Before cutting any type
of material, be sure it is firmly
anchored or clamped to prevent
slipping. Holding the work by hand
or against your body leaves it
unstable and may lead to loss of
control.
• Whenever possible, the saw foot
plate must be held firmly against
the material being cut. This will
prevent the saw from jumping
or vibrating and minimize blade
breakage.
LED Work Light
WORKING HINTS FOR YOUR
MULTI-PURPOSED SAW
If your power tool becomes too hot, run no-load for 2-3
minutes to cool the motor. Avoid prolonged usage at very
low speeds.
12 12
Any movement of the material may affect the quality of
the cut. The blade cuts on the upward stroke and may
chip the uppermost surface.
Ensure your uppermost surface is a non-visible surface
when your work is finished.
MAINTENANCE
Your power tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Always store
your power tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation
slots. This is normal and will not damage your power
tool.
20V Li-Ion multi-purpose saw
TROUBLESHOOTING
Symptom
The tool
suddenly
stops during
operation.
See Fig. G1 – G3
ENVIRONMENTAL
PROTECTION
See Fig. H
retailer for recycling advice.
FOR BATTERY TOOLS
The ambient temperature range for tool and battery use
and storage is 0
The recommended ambient temperature range for the
charging system during charging is 0
Possible
Causes
Over load
Battery
temperature
too high
Low battery
capacity
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
C-45 C.
O O
Possible
Solution
Relieve the load
on the machine
immediately and
allow cooling
for approx. 30
seconds by
running the
machine on
no-load.
Charge the
battery pack.
C-40 C.
O O
EN