Coffee Preparation; Hot Water Delivery; Steam Delivery; Switching Off - Bezzera HOBBY Manual De Instrucciones

MOD. BEZZERA HOBBY
2) Make sure there is enough water in the tank.
Do not use the machine if the drain tray is
not properly inserted in its slot.
Check the cleaning and the emptying of
the drain tray.
3) Press the main switch (1) (yellow switch light
on).
4) Insert the filter holder (21) and wait until the
machine heats to the right temperature that is
indicated by the green light turning on (3).

5.3 Coffee preparation

1) Wait until the green light (3) turns on indicating
that the machine has reached ideal coffee mak-
ing temperature.
2) Remove the filter holder from the machine and
insert ground coffee using the supplied meas-
uring cup (18) in the filter holder with 1 cup
filter (15) to make a single cup of coffee or in
the 2-cup filter (14) to make two cups of coffee
simultaneously. In the 1-cup filter, pour in one
coffee dose, in the 2-cup filter, pour in two cof-
fee doses; then pack the ground coffee exerting
slight pressure using the supplied press (19).3)
Reattach the filter-holder to the filter-holder unit
(7).
4) Place a cup under the machine filter holder
(13).
5) Press the coffee switch (4) (yellow switch light
on) until the desired amount of coffee is made.
6) Press the coffee switch again (4) (yellow switch
light OFF) to stop making coffee.

5.4 Hot water delivery

1) Wait until the green light (3) turns on indicating
that the machine has reached ideal hot water
making temperature.
2) Place a container under the steam/water distri-
bution nozzle (6)
3) Open the water/steam faucet by rotating the
knob (5) counter-clockwise and press the pump
switch (2).
4) After dispensing the desired amount of water,
rotate the water/steam faucet knob (5) clock-
wise and press the pump switch again (2) to
stop distribution.

5.5 Steam delivery

Proceed as follows to distribute steam:
1) Press the steam switch (20) (yellow switch light
on) and open the water/steam faucet by rotat-
ing the knob (5) counter-clockwise until steam
flows from the water/steam distribution nozzle
(6).
2) Close the water/steam faucet by rotating the
knob (5) clockwise and wait until the green light
turns on (3) to indicate that the temperature has
been reached for steam distribution.
3) Submerge the water/steam distribution noz-
zle (6) in the drink to be heated and open the
water/ steam faucet by rotating the knob (5)
counter-cloockwise.
4) Heat the drink as desired, discharge some
steam to clean the nozzle.
5) Close the water/steam faucet by rotating the
knob (5) clockwise and turn the steam switch
(20) to 0 (yellow switch light OFF) to stop steam
production.
After producing stem, fill the boiler as
follows:
1) Make sure the steam switch (20) is in Position 0
(yellow switch light OFF).
2) Place a container under the steam/water distri-
bution nozzle (6)
3) Open the steam/water faucet by rotating the
knob (5) counter-clockwise.
4) Press the pump switch (2) until water continually
flows from the water/steam distribution nozzle
(6).
5) Press the pump switch (2) and close the water/
steam faucet by rotating the knob (5) clock-
wise.
The machine is ready for normal use.
After use in steam mode, always
check turning off the steam
switch (20) (yellow switch light
OFF).

5.6 Switching off

Press the main switch (1) (yellow switch light off).
If the machine is left off for a prolonged period
of time:
1) Empty the tank
2) Disconnect the plug from the electrical socket.
3) Place the machine in a safe, dry and exclusively
accessible place.

6 - MAINTENANCE

To allow the machine to work correctly, follow the
24