, WARNING
Electrical
Shock Hazard
Unplug power cord from electrical
outlet.
Do not operate the cleaner
without the primary or exhaust filters.
Be sure the filters are properly
installed to prevent motor failure
and!or electrical shock,
PRIMARY FILTER
Check primary filter frequently
and clean
when dirty,
TO REMOVE
PRIMARY
FILTER
Remove the dust bin and dust bin lid
assembly
as outlined
in the DUST BIN
CLEANING
section, While holding the pri-
mary filter over a trash container grasp filter,
rotate and lift off.
Clean primary filter by
Filter.._ _
gently tapping over a trash
container
Locking
Tab
Tap on several
sides to
Slot
ensure best
Filler
cleaning,
c_ vet
Rinse with water only as needed
(see
Dust Bin Cleaning),
When cleaning the filter no longer restores
vacuum suction to full power you need to
replace the filter..
TO REPLACE
PRIMARY
FILTER
Make sure that the slots
of the filter line up with
the locking tabs on the
filter cover. Replace filter
and rotate filter until
slots lock onto tabs
in cover.,
i=lt[er
C01tef
Slo
hocking
Tab
Note: Under normal use and care, your fil-
ter can be expected
to last up to 3 years.
Re-attach the filter cover and filter to dust
bin (see Dust Bin Cleaning)° Place dust bin
back into cleaner
EXHAUST FILTER
ELECTROSTATIC
The exhaust filter must be replaced when
dirty. It should be replaced regularly
depending
on use conditions.
The filter CANNOT
be washed
as it will
lose its dust trapping
ability,
Press inward on each side of
I _
exhaust filter cover and pull out 1
to remove from vacuum
Press
cleaner,
Inward
Exhaust
Remove the
frame and filter°
Replace the
exhaust filter,
carefully posi-
tioning it so
that it fits into
the frame°
The white side
of the filter
should be fac-
ing towards the
operator.
Filter
Frame
Filter
White Side
Push only on filter frame, not on filter itself.
Exhaust
Filter
Cover
\
Replace the
exhaust filter
cover by placing
tabs in slots and
pushing in until
cover snaps into
place.
t5