TROUBLESHOOTING
Tuner section
Cause
No reception.
Beat noise heard.
Noise heard.
Sound is distorted.
Compact disc player section
Magazine is not expelled when
EJECT button is pressed.
When
playback is started, it
stops immediately.
Pauses or stops playback.
No sound.
Sound
is distorted,
noise
is
output.
With certain discs, loud noise is
produced, or play stops.
Remote Control Unit
Remote control does not work.
Soh!
* Antenna is not connected.
*® Wrong radio band.
® Station not tuned in.
® Input selector not set to TUNER.
aye eres
Remedy
* Connect antenna correctly.
® Set to desired radio band.
® Turn in station.
® Set to TUNER.
TV is on.
Loop antenna position is bad.
Interference from nearby fluorescent light, hair
dryer, or other electrical appliance.
Not tuned in correctly.
¢ Antenna is in poor position.
© Broadcast is weak.
;
@ Interference from other electrical devices or
multipath reception.
® POWER
switch
of amplifier
section
is
STANDBY.
® Disc is loaded upside down.
* Contaminated disc, etc.
* Incorrect operation of amplifier section.
¢ Player is in pause mode.
® Interference is being picked up from a TV set.
® Disc is badly scratched or warped.
* Disc is extremely dirty.
® Batteries are dead or no batteries in remote
control unit.
é
® Poor angle or too great a distance from the
remote sensor window.
® There is an obstacle between you and the
remote sensor window.
° A fluorescent light is shining on the remote
sensor window.
© Turn off TV or move TV away.
* Change loop antenna position.
® Stop using device causing interference.
Use tuner controls to tune in station.
° Change antenna position.
° Use external antenna.
Change antenna position.
Press POWER switch ON. —
° Load the disc correctly with the label side UP.
Press (p/M) button,
=
-
7
* Clear the fog from the disc and then play it
again.
Check the setting
of amplifier
switches
and
sound volume controls.
Press (m/II) button.
Switch OFF TV set, or move player away from
TV set.
® Replace the disc.
® Clean the disc.
Insert new batteries.
Use within seven meters and within a 30 degree
angle of the remote sensor window.
Change your position or move the obstacle.
© Turn
off the light.
Turntable" "
Platter does not turn.
No sound.
Noise or scratchy sounds.
¢ Input selector not set to PHONO.
® Set to PHONO.
® Dust on record.
® Scratch on record.
¢ Clean record.
® Use good record.
54
<ARE7040>
En/Sp/Ch