Publicidad
Idiomas disponibles
Idiomas disponibles
WHEN TO PERFORM A LEAK TEST:
•
After assembling your grill and before lighting for the
first time, even if purchased fully assembled.
•
Every time the LP gas cylinder is refilled or if any of the
gas components are replaced.
•
Any time your grill has been moved.
•
At least once per year or if your grill has not been used
for more than 60 days.
CHECKING FOR LEAKS:
After all connections are completed, check all connections and
fittings for leaks with a soap solution.
• With all valves closed, apply the leak check solution (50/50
mix of dishwashing detergent and water) to all gas carrying
connections, fittings and to tank seams.
• Open tank valve.
Presence of bubbles at areas of wet solution indicates a gas
leak. If leaks are detected or you smell or hear gas, shut off
the valve and repair the leak or replace the defective part. Do
not use the smoker until all leaks are corrected.
LP tanks are intended for operation in the upright position
only.
If the appliance is not in use, the gas must be turned off at
the supply cylinder and the cylinder should be disconnected
from the appliance.
Storage of the appliance indoors is only permissible if the
cylinder is disconnected and removed from the appliance.
Ensure that the grill is properly
assembled.
Inspect the gas supply hose for burns, chaffing,
kinks, and
proper routing before each use. If it is evident there is excessive
abrasion
or wear, or the hose is cut, it must be replaced
prior
the grill being used. In order to insure proper operation,
any
replacement
of the fuel tank regulator
must be done with
identical
replacement
parts. Call 1-800-848-8915
for
replacement
parts.
Leak check all gas connections
and hose. See section on "Leak
Testing".
Make sure all electrical appliances are connected to grounded
power source.
Ensure that all electrical
supply cords are properly
grounded.
Keep any electrical
supply cord and the fuel supply hose away
from any heated
surfaces.
Hose should be at least 3 inches
from hot surfaces.
Position your grill on level ground in a well ventilated
location,
a
safe distance
from combustible
materials,
buildings
and
overhangs.
Properly
place the empty grease tray under the grease drain
hole in the bottom of the grill to catch grease during
use.
DO NOT obstruct
the flow of combustion
and ventilation
air.
Read, understand and follow all warnings and instructions
contained in this manual. DO NOT skip any of the warnings
and instructions contained in the preceding sections of this
manual.
Property damage, bodily harm, severe burns, and death
could result from failure to follow these safety steps. These
steps should be performed after the grill has been
assembled and prior to each use. DO NOT operate this grill
until you have read and understand ALL of the warnings
and instructions in this manual.
LIGHTING INSTRUCTIONS:
Follow the instructions exactly.
1.
OPEN THE GRILL LID before attempting to light a
burner so that fumes do not accumulate inside the grill.
An explosion could occur if grill lid is closed.
2.
Make sure that all burners are off.
3.
Turn on the fuel supply by rotating the cylinder valve
knob counter-clockwise to full open.
4.
DO NOT stand with head, body, or arms over the grill
when lighting.
10
Publicidad
