Publicidad
Idiomas disponibles
Idiomas disponibles
6. Wall Mounting the Enclosure
• Enclosure must be installed by a qualified technician. Before mounting, use a level and tape measure to position your
mounting area precisely. Use a minimum of four screws (not included, sizes will vary by model) to secure the enclosure in
place. A fender washer with close cell foam is provided with the cabinet. The close cell foam side of the washer should be
against the cabinet to seal the mounting hole.
• Make sure mounting screws are anchored into the center of the studs. Use of a stud finder is highly recommended.
• If there is no stud at the mounting location, it is recommended you install studs at the desired location to secure the
enclosure in place. DO NOT use plastic expansion wall anchors, threaded drywall anchors, threaded drywall toggles,
sleeve-type hollow wall anchors (a.k.a. molly bolts) or toggle bolts, due to the weight of the enclosure.
• Use suitable mounting means when installing to cinder block, concrete, or wood studs. It is the installer's responsibility to
choose suitable mounting hardware (not supplied). Do NOT use plastic expansion wall anchors, threaded drywall anchors,
threaded drywall toggles, sleeve-type hollow wall anchors (a.k.a. molly bolts) or toggle bolts, due to the weight of the
enclosure.
• If placing the enclosure over a telecommunications receptacle, remove the wall plate, then fasten the enclosure to the
wall. Once secured, fasten the wall plate over the receptacle.
• If no telecommunications receptacle is available, a surface mount box (or biscuit jack) and equipment cord can be
mounted inside the unit.
• Use an adhesive-backed surface mount box.
2. Use a Drill and Punch (Such as
a Greenlee) to Create a Bottom
Conduit Cutout
Note: This conduit cover supports a maximum Conduit Trade
Size 2 with 2.5" hole.
3. Run Data and Power Cable (If
Required) Through the Conduit
Cutout
Note: To maintain a NEMA rating, use sealed fittings in the
cutouts when connecting to conduit. Accessory gland plates
with model numbers SRGP1KO, SRGP2KO, SRGP3RM and
SRGP4PLASTIC are available (sold separately).
8
Publicidad
