HJM ENV396 Instrucciones De Uso página 38

Envasadora_Maquetación 1 07/07/16 12:15 Página 38
TROUBLE SHOOTING
Nothing happens when I press the ''Vacuum & Seal'' button:
- Make sure the power cord is correctly plugged into the electrical
outlet.
- Make sure the power cord is not damaged in any way.
- Make sure the electrical outlet is operative by plugging in another
appliance. If it's not, please check the circuit breakers or fuses in
your home.
- Make sure the bag is positioned correctly down in the vacuum
chamber.
- Press down on both sides of the lid and make sure it is locked in place.
- Wait 25 minutes to allow appliance to cool off, and then try using
again.
Air is not vacuumed from the bag:
- Check that there are no gaps, folds, wrinkles or holes in the pre-
sealed bags.
- Check for loose, worn or cracked Upper and Lower sealing gaskets.
- Foods with high liquid contents may prevent the bag from sealing
properly. Cut bag open and wipe top inside of bag and reseal.
- Check to see if bag is properly inserted into the vacuum chamber.
- Make sure you've placed the bag in the proper place. When making
a bag from a roll, make sure end of cut piece is on the sealing strip.
Bag melts:
- The sealing strip may have been too hot during the sealing process.
Allow the unit to cool for 20 seconds between uses. If the bag con-
tinues to melt, allow unit to cool with the lid in the upright position
for 25 minutes before using.
Air has seeped back into the vacuumed bag:
- Check the seal of the bag. There may be a hole or wrinkle that is
allowing air to reenter the bag. Carefully cut the bag open and re-
seal it, or use an entirely new bag.
- 38 -