Extension Cords - Bosch FNH180K-16 Instrucciones De Funcionamiento Y Seguridad

BM 2610011761 10-10:BM 2610011761 07-10.qxp 10/5/10 9:24 AM Page 18
If an extension cord is
W RNING
necessary, a cord with
adequate size conductors that is capable of
carrying the current necessary for your tool
must be used. This will prevent excessive
voltage drop, loss of power or overheating.
Grounded tools must use 3-wire extension
cords that have 3-prong plugs and
receptacles.
NOTE: The smaller the gauge number, the
heavier the cord.
No-Mar Tip
The No-Mar Tip on the nose of the work
contact element protects the work piece from
unintentional marring from bare metal wire
nose when compressed during actuation. The
tip can be removed and replaced.
Disconnect the battery pack
W RNING
from the tool and remove
nail strips before removing or replacing no-

Extension Cords

RECOMMENDED SIZES OF ExTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
Tool's
Ampere
Rating
3-6
6-8
8-10
10-12
12-16
Accessories
mar tips. Such precautionary safety measures
reduce the risk or unintentional tool operation.
To remove the tip: Pull the no mar tip towards
the back of the tool following the bend of the
wire nose.
To replace the tip. Push the no mar tip on to
the tool inserting the opening of the no mar tip
on to the wire nose.
-18-
Wire Sizes in mm
Cord Size in A.W.G.
Cord Length in Feet Cord Length in Meters
25 50 100 150 15
18 16 16 14 0.75 0.75 1.5
18 16 14 12 0.75 1.0 2.5
18 16 14 12 0.75 1.0 2.5
16 16 14 12 1.0 2.5 4.0
14 12 — — — —
2
30 60 120
2.5
4.0
4.0
—
— —