Publicidad
2.
After securing the unit to the wall with screws, open it completely as shown below, and tighten the vertical frame's left
and right screws (c).
3.
Attaching the Plasma Display
1.
Using 2 persons to hold the display as shown below, insert the 4 monitor securing bolts into the holes on the wall hanging
bracket.
Insert lower bolts into holes before inserting upper bolts.
Once the above procedure is done, attachment of the monitor is finished. Setting the display to a suitable angle is done
next.
10
<AZR1041>
En
c
Display
Wall side
Tighten the screw from the top
to prevent loosening.
Tighten nut.
Insert the monitor se-
curing bolts in the wall
hanging
bracket's
holes and slide down-
wards.
Publicidad
