Assembly & Set-Up - Medela Waterless Milk Warmer Instrucciones De Uso

Assembly & Set-Up
1.
Remove warmer from shipping container. Allow unit to reach
room temperature before use.
2.
Review instructions prior to assembly.
3.
Connect the power cord (provided with the warmer) into the
socket located on the back of the unit.
4.
Push the wire cord retainer (located around the warmer power
socket) down over the plug until secure.
Placement on Counter or Hard Surface
1. Make sure that surface is clean and dry.
2. Place the warmer on a solid surface. Ensure the surface is
secure to avoid the warmer from tipping or falling
3. Place the warmer on a surface low enough for staff to see
into the warmer cavity.
4. Do NOT block vents on the back of warmer. Do NOT place
on a soft surface to avoid blocking the bottom vent on the
warmer.
Note: For ideal sound pressure level, the recommended
placement location is 1 meter or greater from the patient.
Bottom Rear
9