GE WSLP1500 Manual Del Propietario E Instalación página 12

Installation Instructions
WASHER CONNECTIONS FOR STATIONARY MODEL WSLS1500
[_] INSTALLATION CHECKLIST
Before starting the washer, check to make sure:
Main power is turned on.
The washer is plugged in.
The water faucets are turned on.
The unit is level.
The drain hose is properly tied up.
There are no leaks at the faucet, drain line
or washer.
[] RUN THE WASHER THROUGH A
COMPLETE CYCLE
Check for water leaks and proper operation.
[_] REMOVE THE PROTECTIVE FILM
COVERING THE CONTROL PANEL
i91 READ THE REST OF THIS OWNER'S
MANUAL
It contains valuable and helpful information that will save
you time and money.
OWNERS
MANUAL
NOTE:If your washer does not operate, please review
the Before YouCo!!For Service section.
ALCOVE OR CLOSET INSTALLATION
If your washer is approved for installation in an alcove or
closet, there will be a label on the back of the machine
describing requirements.
, Minimum clearances between washer and adjacent
walls or other surfaces are: 0" either side, 2" front,
3" rear.
, Minimum vertical space from floor to overhead
shelves, cabinets, ceilings, etc. is 96t'
. Closet doors must be Iouvered or otherwise ventilated
and have at least 60 square inches open area for
washer only, or if the closet contains both a washer
and dryer, doors must contain at least 120 square
inches of open area equally distributed.
NOTE:The clearances stated on this label are minimums.
Consideration must be given to providing adequate
clearances for installation and servicing.
O
I i
I I
Closetdoor
$
68 sq+ in.
(387.1sq+cm)
€
68 sq+ in.
(387.1sq+cm)
12