MECH MIND NANO Manual De Usuario página 3

2. Certifications
Mech-Eye Industrial 3D Camera is compliant with the following standards and
assessment requirements. Please note that the certification statuses may be
updated. For more information, please contact the local sales agents.
Compliant with the Requirements and Standards:
European Electromagnetic Compatibility Standards.
●
U.S. ANSI C63.4 and 47 CFR PART 15B.
●
Canada ICES-003.
●
Japan VCCI-CISPR 32: 2016.
●
South Korea KS C 9832 and KS C 9835
●
Safety of Laser Products:
The Laser classification is implemented based on IEC 60825-1 in accordance with
the requirements of Laser Notice No. 56 of the FDA (CDRH).
The full text of the EU Declaration of Conformity is available at
https://www.mech-mind.com/download/camera-information.html
European Electromagnetic Compatibility Standards:
EN 55032: 2015 + A1: 2020
●
EN IEC 61000-3-2: 2019 + A1: 2021
●
EN 61000-3-3: 2013 + A1: 2019 + A2: 2021
●
EN 55035: 2017 + A11: 2020
●
All products bearing this symbol are waste electrical and electronic equipment
(WEEE as in directive 2012/19/EU) which should not be mixed with unsorted
household waste. Instead, you should protect human health and the environment
by handing over your waste equipment to a designated collection point for the
recycling of waste electrical and electronic equipment, appointed by the
government or local authorities. Correct disposal and recycling will help prevent
potential negative consequences to the environment and human health. Please
contact the local authorities for more information about the location as well as
terms and conditions of such collection points.
03
NOTE: This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation of the device.
"Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement."
This is a Class A equipment. Operation of this equipment in a residential
environment could cause radio interference. In such a case, the user may be
required to take corrective actions.
EN EN
VCCI-A
04