MECH MIND NANO Manual De Usuario página 5

6. Mount the Camera
* For more information, please visit
https://www.mech-mind.com/download/camera-information.html.
Mount through the Camera Bracket
Use a wrench to tighten the two nuts, as shown below.
* The camera bracket is attached to the back of the camera when packaged.
Mount through Threaded Holes
Use a wrench to loosely screw on the bolts in the order specified below, and
then fully tighten all the bolts.
1
3
4
2
* Please remove the camera bracket before mounting.
07
7. Connect the Camera
Ethernet Cable
Insert one end into the port on the IPC and the other end into the ETH port on
the camera.
Power Cable
Insert the DC power cable connector of the adapter/DIN rail power supply into
the DC 24V port, as shown below.
DIN rail power supply DC power cable
Bump
Notch
①
When inserting the Ethernet cable and power cable:
① Make sure the bump on the connector is aligned with the notch
of the port.
② Tighten the nut after inserting the cable.
Attention:
Network switch can be used to connect the camera and IPC.
●
The PWR indicator light should turn on after the cables are connected. If the
●
light is not on, please contact Mech-Mind Technical Support.
The recommended tightening torque for the bolts is 16 N·m.
●
The DIN rail power supply should be reliably grounded. If using multiple DIN
●
rail power supplies, ensure enough distance in between when mounting.
EN EN
Ethernet cable
② About 2-mm gap
08