HIKOKI CD 3605DB Instrucciones De Montaje página 13

Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/EU
on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
V Rated voltage
n
No-load speed
0
Switching ON
Switching OFF
Disconnect the battery
Prohibited action
Mode selector switch
Lighting mode switch
Always ON (turn off after 2 minute)
Light only SW-ON
Always OFF
Remaining battery indicator switch
APPLICATIONS
Standard
For cutting soft steel materials*
accessories
It is possible to cut aluminum. However, when doing so, apply cutting oil to the edge of the blade.
*
Optional accessories are subject to change without notice.
CAUTION
○ Do not connect with a cleaner when cutting steel materials.
○ Empty the inside of the saw cover when changing the materials to be cut.
○ Do not consecutively cut metal plates.
Blades
O For cutting various types of soft steel materials such as
13
Battery
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50%–75%.
Lights ;
The battery remaining power is 25%–50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 2 minutes.
STANDARD ACCESSORIES
In addition to the main unit (1 unit), the package contains the
accessories listed on page 288.
Standard accessories are subject to change without notice.
Uses
steel pipe, steel channels ("C" channels, "L" angles etc.)
and aluminum sash.
Cannot be used for cutting tempered steel materials.
English