Publicidad
Idiomas disponibles
Idiomas disponibles
,='_WARNING:
If received
assembled,
repeat all steps to ensure your unit is properly
assembled
and all fasteners
are secure.
Examh_e parts for damage.
Do not use dam-
aged parts.
NOTE:
If you need assistance
or find parts
missing
or damaged,
call 1-800-554-6723.
TOOLS
REQUIRED
• Hex wrench
(provided)
INSTALLING
PRUNER
ATTACH-
MENT
CAUTION:
When removing
or installing at-
tachments,
place the unit on a flat surface
for
stability.
1.
Loosen
the coupler
by turning
the knob
counterclockwise.
Coupler
_OOSEN
SHOULDER
STRAP
ASSEMBLY
_, WARNING:
Proper shoulder strap and
handle adjustments
are required before use.
The shoulder strap clamp must be installed as
shown above the assist handle on the upper
shaft (powerhead
end of unit).
NOTE:
The lower shoulder strap clamp has
two spacer tabs attached.
These
tabs are
provided to adapt this attachment
for use with
powerheads
that have a I inch (2,5 cm)diam-
eter upper shaft (the shoulder strap clamp will
not tighten down securely
on the 1 h_ch (2,5
cm) diameter
upper shaft without using these
spacer
tabs).
The tabs must be broken
off
completely
before
use and placed
over the
screw
holes
on the
lower
shoulder
strap
clamp. These tabs are not needed for power-
heads with a 7/8" (2,2 cm) upper shaft.
LOWER
SHOULDER
STRAP
CLAMP
2.
3.
4.
TIGHTEN
Knob
Remove the shaft cap from the pruner at-
tachment
(if present).
Position locking/release
button of attach-
ment into guide recess
of coupler.
Push the attachment
into the coupler
until
the IocMng/release
button snaps into the
primary hole.
Before using the unit, tighten the knob se-
curely by turning clockwise.
Coupler
Primary
Hole
__
_r_l_'---_i_jl_uide
Recess
UpPaeftr
Reieage /
AttL°c_elrent
Button
,&
d_,WARNING:
Make sure the locking/
retease
button
is locked
in the primary
hole
and the knob is securely
tightened
before op-
erating
the unit. Using the wrong hole could
lead to serious injury or damage to the unit.
Secondary
Hole
Locking/Release
Button in Primary
Hole
1,
2.
__.d_-_
Spacer Tabs
_w-
positioned
for use
on 1 inch (2,5 cm)
diameter
upper shaft
Place the
upper
shoulder
strap
clamp
over the upper shaft above the handlebar.
Position
the lower shoulder
strap clamp
under the upper shaft and align the upper
and lower clamp screw holes
(use spacer
tabs between
upper and lower clamps if
necessary
to secure clamp,
i.e. for 1 inch
(2,5 cm) diameter
upper shaft).
POWERHEAD
END
Strap Clamp
i
Lower Shoulder
•
ATTACHMENT
Strap Clamp
|
_
END
!
Screws
3.
Insert two screws
into the screw
holes.
4.
Secure shoulder
strap clamp by tighten-
ing screws
with the hex wrench.
5.
Try on shoulder strap and adjust for fit and
balance before starting the engine or begin-
ning a cutting operation.
6.
Insertyour
right arm and head through the
shoutder strap and allow it to rest on your
left shoulder.
Make sure the danger sign
6
Publicidad
