Working With The Tool; Maintenance And Care; Sanding Base Brakes; Accessories, Tools - Festool ETS 125 Q Manual De Instrucciones

Working with the tool

Always secure the workpiece in
such a manner that it cannot move while being
sanded.
Never overload the tool by using too
much pressure! The best sanding results are
achieved when applying moderate pressure.
The sanding performance and quality depend
mainly on the choice of the right sanding material.
Festool offers the appropriate sanding material for
all applications (see Festool catalogue).
We recommend the following settings on the
rotary control (2.1) for electronic machines:
5 - 6
• sanding with max. drive
• sanding old paint
• sanding wood and veneer prior to painting
• interim sanding of paint on surfaces
4 - 5
• sanding of thinly applied primer
• sanding of wood with sanding vlies
• sanding edges on wooden parts
• smoothing primed wooden surfaces.
3 - 4
• sanding full wooden and veneer edges
• sanding in the grooves/rebates of windows and
doors
• interim paint sanding on edges
• pre-sanding natural wood windows with sanding
vlies
• smoothing wood surfaces with sanding felt prior
to staining
• rubbing down stained surfaces with sanding
vlies
• rubbing down or removing excess lime paste
with sanding vlies
2 - 3
• interim paint sanding on stained surfaces
• cleaning natural wood window grooves with
sanding felt
1 - 2
• sanding stained edges
• sanding thermoplastic synthetics

Maintenance and care

Always remove the plug from the
mains supply socket before carrying out any work
on the machine!
The cooling air vents on the motor housing must
always be free of blockages and clean to ensure
air circulation. Any maintenance or repair work
requiring the motor housing to be opened may
only be carried out by an authorised service
workshop.

Sanding base brakes

The sanding base is braked by a collar (6.1) in
order to prevent any uncontrolled excessive speed
of the sanding base.
6.1
Because the collar wears down in the course of
time, it has to be replaced by a new one (order
no. 489 190) as soon as there is any reduction in
the braking effect.

Accessories, tools

For safety reasons, only use original
Festool accessories and tools!
The accessory and tool order number can be
found in the Festool catalog or on the Internet
under www.festool-usa.com.
Many Festool products are shipped in a unique
system container, called "Systainer". This provides
protection and storage for the tool and acces-
sories. The Systainers are stackable and can be
interlocked together. They also can be interlocked
atop Festool CT dust extractors.
- Place one systainer on top of the other.
- Release all four latches on the lower systainer
by pulling back at their top edges (7.1).
- Slide all four latches upward (7.2).
- Snap all four latches back to their fl at position
(7.3) so they engage the stacking tabs of the
upper systainer.
5
Systainer
7.3
7.1
7.2