Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
7
Installing the handle
□
Thread the connector (O) onto the valve stem (1).
Place the handle seat (M) onto the right (cold)
ange (Q) and the handle (J) onto the handle
seat (M). Place the set screw (N & K) into handle
seat (M) & handle (J) and tighten set screw
(N & K) with the Hex wrench (Hex: 2.5mm, L).
□
Place the other handle onto the left (hot) valve
and install the same way.
9
Making the water supply
connections
□
Connect the water supply lines (1) to the
faucet inlets (2). (Supply lines are not
included.)
8
□
□
□
J
K
L
L
N
M
O
1
Q
6
Connecting the hoses
Connect the hoses (W) to the bottom of the hot
and cold end valves (R & S), as shown.
Align the middle body (F) in a position that will
allow maximum clearance to connect the
hoses (W).
Carefully bend the hoses (W) to t in the
available space, and carefully thread the hose
(W) couplings onto the sides of the middle
body (F). Tighten all connections with a wrench.
R
F
W
W
2
1
S
Publicidad
