Publicidad
Idiomas disponibles
Idiomas disponibles
2
2.1. Insert the fixed panel bottom seal strip (N) on the base of the fixed panel (C). Cut the surplus part with a cutter, about 1 9/16
in from the panel's edge.
2.2. Insert the fixed panel (C) into the wall track (B). Do not fully tighten it as further adjustments may be required.
Note: The wall track (B) allows you to adjust the position of the fixed panel (C). Adjusting the depth and/or giving the
2.3. Smoothly slide the sliding door guide (A) at the bottom of the fixed panel (C), but without securing it.
2.1
C
N
1 9/16 in
B
C
N
RIGHT DOOR OPENING
FIXED PANEL AND SUPPORT BAR INSTALLATION
glass panel a slight angle allows for out of plumb adjustment.
B
A
2.2
C
LEFT DOOR OPENING
2.3
C
A
B
C
A
N
PAGE 11
Publicidad
