Tecsis P3308 Instrucciones De Uso página 16

5. For your safety / 6. Packaging

Open pressure connections only after the system is without pressure!

!
Please make sure that the pressure sensors is only used within the overload
threshold limit all the time!

Warning
Observe the ambient and working conditions outlined in section 7
„Technical data".

Ensure that the pressure sensors is only operated in accordance with the provisions i.e. as
described in the following instructions.

Do not interfere with or change the pressure sensors in any other way than described in
these operating instructions.

Remove the pressure sensors from service and mark it to prevent it from being used again
accidentally, if it becomes damaged or unsafe for operation

Take precautions with regard to remaining media in removed pressure sensors.Remaining
media in the pressure port may be hazardous or toxic!

Have repairs performed by the manufacturer only.
6. Packaging
Has everything been supplied?
Check the scope of supply:

Completely assembled pressure transmitters

Inspect the pressure sensors for possible damage during transportation. Should there
be any obvious damage, inform the transport company and tecsis without delay.

Keep the packaging, as it offers optimal protection during transportation (e.g. changing
installation location, shipment for repair).

Ensure that the pressure connection thread and the connection contacts will not be
damaged.
16 Betriebsanleitung/Operating instructions/Mode d'emploi/Instrucciones de servicio
GB