Melchioni Family FACILE Manual De Instrucciones página 13

the iron leaks water. The iron must be sent to the manufacturer, its Technical Assistance Service
or in any case to an Authorized Center before using it again.

Do not leave the appliance exposed to atmospheric agents (rain, sun, etc.). Do not keep the
appliance near heat sources (eg radiator).

Do not let the cord hang over the edge of the table or counter or touch hot surfaces.

Do not place on or near a hot gas or electric stove or a hot oven.

This appliance must not be used by people (including children) with reduced physical, sensory
or mental capabilities; by people who lack experience and knowledge of the appliance, unless
they are carefully supervised or well trained in the use of the appliance by a person responsible
for their safety.

Make sure that children do not play with the appliance.

If you decide to dispose of this appliance as waste, it is recommended to render it inoperative
by cutting the power cord. It is also recommended to render harmless those parts of the
appliance that could create a danger, especially for children who could use the appliance for
their own games.

Do not leave the appliance unattended while it is connected to the mains.
WARNINGS FOR USE

Check that the voltage of the electrical network corresponds to that indicated on the label.

In case of damage to the cable, plug or short circuit, do not use the iron and have it repaired by
an authorized service center.

The appliance must be used on an ironing board or on a stable surface.

When placing the device on the support, make sure that the surface on which the support is
positioned is stable.

When using the iron for the first time, remove the protective film from the soleplate.

When used for the first time, the plate may emit a light smoke due to the evaporation of the
protective oil, applied during the manufacturing phase; this should not cause any concern and
after a few uses the smoke will disappear.

It is possible that residues remain in the tank during the manufacturing phase; when using the
iron for the first time, release the steam several times away from the garment to be ironed to
eliminate internal residues.

The electric cable must always be free from knots or tangles. Do not grab the cord to
disconnect the plug.

Do not wrap the electric cable around the iron.

Keep the power cord at a safe distance from the plate, especially when it is hot.

Always put the iron in an upright position when working breaks and when you are not using the
iron.

Before filling or emptying the tank, always disconnect the plug from the electrical socket.

Let the appliance cool down before putting it away.

Do not fill the tank with quantities of water greater than the maximum capacity.

Do not introduce stain remover mixtures, vinegar, descaling agents or chemicals in the tank,
use only distilled or demineralized water.

The soleplate of the iron becomes very hot; be careful not to get burned. Be careful not to
bring your face close to the steam that comes out of the soleplate.

Do not touch hot surfaces. Use the handle or knobs
12