Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
STEP
12
Connect
Door Arm to Trolley
Follow instructions which apply to your door type as
illustrated below and on the following page.
SECTIONAL DOORS ONLY
• Make sure garage door is fully closed. Pull the
emergency release handle to disconnect the outer
trolley from the inner trolley. Slide the outer trolley
back (away from the pulley) for 8" (20 cm)
minimum as shown in Figures 1, 2 and 3.
• Figure 1:
- Fasten straight door arm section to outer trolley
with the 5/16" x 1" clevis pin. Secure the
connection with a ring fastener.
- Fasten curved section to the door bracket in the
same way, using the 5/16" x 1-1/4" clevis pin.
• Figure 2:
- Bring arm sections together. Find two pairs of
holes that line up and join sections. Select holes
as far apart as possible to increase door arm
rigidity.
• Figure 3, Hole alignment
alternative:
- If holes in curved arm are above holes in straight
arm, disconnect straight arm. Cut about 6"
(15 cm) from the solid end. Reconnect to trolley
with cut end down as shown.
- Bring arm sections together.
- Find two pairs of holes that line up and join with
bolts, lock washers and nuts.
• Pull the emergency release handle toward the
opener at a 45 ° angle so that the trolley release
arm is horizontal. Proceed to Adjustment Step 1,
page 28. Trolley will re-engage automatically when
opener is operated.
HARDWARESHOWNACTUALSIZE
© ©0
Nut 5/16"-18
Lock Washer 5/16"
Ring Fastener
Clevis Pin
Clevis Pin
Hex Bolt
5/16" x t" (Trolley)
5/16" x 1-1/4" (Door Bracket)
5/16"-18 x 7/8"
Pulley
'
i
i
8" (20 cm) min,._)l
Trolley
/
/
Stop Bolt
Inner
_'
Outer
_
Trolley
Ring
Trolley
Clevis Pin
Fastener
5/t6"x1"
/
/
/
Emergency
0
Door
Release
:
Bracket
Straight
Door Arm
Clevis Pin
Curved Door Arm
5/t6"x1
Figure 1
Pulley
/i(.--8"(20cm)
min.
,=L
Trolley
Stop Bolt
Lock
Washers
Nuts
5/16"
5/16"-18
Door Bracket
Figure 2
Pulley
/ i_.--8" (20 cm) rain._.)i
_-
Trto'!eYolt
//
" _
Ly_Ckhers
Nuts
5/16"
5/16".
_
8
8"
Figure 3
26
Publicidad
