Publicidad
Idiomas disponibles
Idiomas disponibles
For proper
orientation
of shield, see
KNOW
YOUR
TRIMMER
illustration in OPERATION
section.
1.
Remove wing nut from shield.
2.
Insert bracket into slot as shown.
3.
Pivot shield until bolt passes through hole in
bracket,
4.
Securely tighten wing nut onto bolt.
Shield
%
pTV_T
"_"
Lin_L_iter
Slot
/
Bracket
/
_
ing
Nut
KNOW YOUR TRIMMER
READTHIS INSTRUCTION MANUAL AND SAFETY RULESBEFORE OPERATING YOUR UNIT
Compare the illustrations with your unit to familiarize yourself with the location of the various controls
and adjustments.
Save this manual for future reference.
Assist
Handle
Muffler
Shaft Mark
Shaft
or Arrow
Safety Label
Trimmer
Head
Shield
/
Spark
Plug
Throttle
Primer
Trigger
Bulb
Choke
Lever
Fuel Mix Fill Cap
Line Limiter
Blade
Starter Handle
STOP
SWITCH
The STOP switch is used to stop the engine. To
stop the engine, push and hold the switch in the
STOP position until the engine stops.
PRIMER
BULB
The PRIMER BULB removes
air from the car-
buretor and fuel lines and fills them with fuel.
This allows you to start the engine with fewer
pulls on the starter rope. Activate
the primer
bulb by pressing
it and allowing
it to return to
its original form.
CHOKE
The CHOKE helps to supply fuel to the engine
to aid in cold starting. Activate
the choke by
moving the choke lever to the FULL CHOKE
position. After the engine attempts to start, move
the choke lever to the HALF CHOKE
position,
Once engine has started, move the choke lever
to the RUN position,
BEFORE STARTING
ENGINE
_
WARNING:
Be sure to read the fuel
information in the safety rules before you
begin. If you do not understand the safety
rules, do not attempt to fuel your unit, Call
1-800-554-6723,
FUELING
ENGINE
_
WARNING:
Remove fuel cap slowly
when refueling.
HELPFUL
TIP
I
\ T°°btainthec°rrect°ilmix
I
I
) ratio, PoUr 3.2 ounces
of
I
2-cycle
synthetic
oil into
One gallon Of fresh gas.
This engine is certified to operate on unleaded
gasoline.
Before
operation,
gasoline
must be
mixed with
a good quality synthetic
2-cycle
air-cooled engine oil designed to be mixed at a
ratio of 40:1.
Poulan/WEED
EATER
brand
synthetic oil is recommended.
Mix gasoline and
4
Publicidad
