Ariston SENSYS Manual De Instrucciones página 65

product description
- ( ) Solar heating system active
(where present)
- ( ) Complete menu:
- ( ) Heating settings
- ( ) Hot water settings
- ( ) System performance
- ( ) Display options
Symbols only displayed with the solar
heating system installed:
- ( ) Boiler
- ( ) Boiler operating
- ( ) Under-fl oor heating system
- ( ) Single-coil indirect cylinder
- ( ) Double-coil indirect cylinder
- ( ) Solar-electric indirect cylinder
- ( ) Solar collector
- ( ) Circulation pump
- ( ) Heat exchanger
- ( ) Diverter valve
S1) Collector sensor
- (
S2) Low indirect cylinder sensor
- (
S3) High indirect cylinder sensor
- (
S4) Under-fl oor heating system
- (
thermostat
- ( ) Indirect cylinder overheating
- ( ) Collector overheating
- ( ) Anti-frost function
- ( ) Anti-Legionnaire's disease function
- ( ) Recooling function
- ( ) Digital display format
- ( ) Analogue display format
- ( ) Confi gurable device
Initial start-up
The fi rst time the SENSYS system inter-
face is connected to the boiler, you will
be asked to select a few basic settings.
First, you will need to select the user in-
terface language.
Turn the knob and select the desired
language, then press the OK button to
confi rm. Move on to setting the date and
time. Turn the knob to make a selection,
press the OK button to confi rm your se-
lection, turn the knob to set the value.
Press the OK button to confi rm.
Save the settings by pressing OK.
Press the OK button to access the Menu.
Use the knob in the centre to scroll
through the menu list and select a pa-
rameter, then press OK to confi rm.
CAUTION
Some parameters are protected with an
access code (safety code) which protects
the boiler settings from unauthorised
use.
GB
65