Publicidad
elitustration shows section DECK IL
eLa ilustracion muestra la secci6n DECK II.
@A ilustragao mostra a segao do DECK IL.
46
<XRE3003>
En
USING THE TIMER
Sleep timer
e This automatically switches power off after a set time has elapsed.
e Operation is by remote control.
*
Press the SLEEP button on the remote control, and the ("g)
indicator lights. Each time you press the button, settings
change as follows:
AUTO
——-* OFF 30 ——-» OFF 60.
on
<—— FF 30 «+ —_
AUTO (Auto Sleep)
e@{f you press the SLEEP button and select AUTO during recording
or when
listening to a CD or tape, power is automatically
switched off after recording is completed or when the CD or
tape finishes playing.
e With relay play, power is automatically switched off after the
tapes in both decks finish playing.
NOTE:
During REPEAT CD play, Auto sleep does not operate.
To cancel sleep timer operation:
Press the SLEEP button to select OFF.
The { » ) indicator goes out.
MAINTENANCE
Cleaning the head section
The heads, capstans and pinch rollers are parts which are liable
to get dirty quite easily. In particular, if the heads are dirty, the
high frequency components of the sound wil! not be reproduced
and the stereo
balance
will be impaired,
resulting
in a
deterioration of sound quality. It is therefore recommended that
the head section be cleaned regularly.
@) Eraser head (DECK II only)
(2) DECK E: Playback head
DECK II: Recording/playback head
(3) Capstans
(4) Pinch rollers
1. Turn the power off.
2. Press the Eject (4) button to open the cassette door.
3. Dip a cleaning swab into head cleaning fluid and use it to
wipe the heads, capstans, and pinch rollers. Wait 2-3 minutes
until the cleaning fluid dries.
Demagnetizing the cassette deck heads
The deck heads
may become
magnetized
after the deck has
been used for a long period of time, or if a magnet or other
magnetized object (screwdriver, etc.) is brought near the heads.
Magnetization
of the heads
results in increased
noise and
reduced ability to reproduce high-frequency sounds.
in this case,
please
use
a commercially
available
head
demagnetizer at regular intervals to eliminate the magnetic
field on the heads. When using a head demagnetizer, turn this
unit's power switch ON. In order to prevent adverse effects on
the receiver and speakers, however, be sure to turn down the
receiver's volume control to its lowest position, and disconnect
any headphones from their headphones jack. For details, consult
the instructions accompanying your head demagnetizer.
| Maintenance of external surfaces
|
e@ Use a polishing cloth or dry cloth to wipe off dust and dirt.
e@When the surfaces are dirty, wipe with a soft cloth dipped in
some neutral cleanser diluted five or six times with water, and
wrung out weil, and then wipe again with a dry cloth. Do not
use furniture wax or cleaners,
eNever
use thinners,
benzine,
insecticide
sprays or other
chemicals on or near this unit, since these will corrode the
surfaces.
Publicidad
