Troy-Bilt TB75SS Manual Del Operador página 14

MAINTENANCE AND REPAIR INSTRUCTIONS
Outer Spool
Inner Reel
4. Use a clean cloth to clean the the inner reel, spring,
shaft, and inner surface of the outer spool.
5. Check the indexing teeth on the inner reel and outer
spool for wear (Fig. 14). If necessary, remove burrs or
replace the reel and spool.
Indexing Teeth
For Use with
Single Line ONLY
Slotted Holes
14
Shaft
Spring
Fig. 13
Fig. 14
For Use with Membrane
or Single Line
Fig. 15
NOTE: Membrane line can only be used with the
inner reel with the slotted holes. Single line can be
used on either type of inner reel. Use Figure 15 to
identify the inner reel you have.
NOTE: Always use the correct line length when
installing trimming line on the unit. The line may not
release properly if the line is too long.
Single Line Installation
Go To Step 8 for Membrane Line Installation
6. Take approximately 20 feet (6.1 m) of new trimming
line, loop it into two equal lengths. Insert each end of
the line through one of the two holes in the inner reel
(Fig. 17). Pull the line through the inner reel so that
the loop is as small as possible.
7. Wind the lines in tight even layers, onto the reel
(Fig. 17). Wind the line in the direction indicated on
the inner reel. Place your index finger between the
two lines to stop the lines from overlapping. Do not
overlap the ends of the line. Proceed to step 11.
Loop
Fig. 16
Fig. 17