Stihl RE 80.0 Manual De Instrucciones página 40

English
10.2 Squeezing and locking the
spray gun trigger
Pressing the spray gun trigger
► Move the retaining latch (1) to the
► Press and hold the trigger (2).
The high-pressure pump starts up automati‐
cally and water flows out of the nozzle.
Locking the spray gun trigger
► Release the trigger (2).
The high-pressure pump switches off automat‐
ically and water stops flowing out of the noz‐
zle. The high-pressure washer is still switched
on.
► Move the retaining latch (1) to the
10.3 Cleaning
According to the application, the following noz‐
zles can be used:
– Fan-jet nozzle: The fan-jet nozzle is designed
for cleaning large areas.
– Rotary nozzle: The rotary nozzle is designed
for removing stubborn dirt.
The user can work close up to the surface in
order to remove stubborn dirt.
The user can work at a distance when cleaning
any of the following surfaces:
– Painted surfaces
– Wooden surfaces
– Rubber surfaces
40
2
1
The fan-jet nozzle is adjustable.
Turning the fan-jet nozzle in the + direction
increases the working pressure.
position.
Turning the fan-jet nozzle in the – direction
reduces the working pressure.
► Before starting work, direct the water jet at an
inconspicuous area of the surface and check
that the surface does not suffer damage.
► Select the distance between the nozzle and
the surface to be cleaned so that the surface
2
to be cleaned is not damaged.
1
► Adjust the fan-jet nozzle so that the surface to
be cleaned is not damaged.
► Move the spray attachment evenly along the
position.
surface to be cleaned.
► Move forward slowly in a controlled manner.
10.4
Detergents can increase the cleaning effect of
the water. The use of the STIHL spraying set is
required for working with cleaning agents. The
STIHL spraying set may be included in the scope
of delivery, depending on the market.
► Dose and use cleaning agent as described in
the user manual for the cleaning agent.
10 Operating the pressure washer
Working with Detergent
2
1
0458-001-8721-B