Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Attention!
Whenever cleaning or servicing,
✔
make sure the equipment is off, and
disconnected from wall outlet.
Never use a water jet to clean the
✔
blower/vacuum. Clean it with a
sponge or cloth, mild detergent and
water. If water runs inside the
equipment, it may damage motor
electric circuits and it will increase
the risk of electric shock.
1.
When not in use, store your equipment in a
dry place, protected from the weather and
out of children's reach and of people not
familiar with it.
Trapp Blower/Vacuum are classified as
Protection Class II - Double or Reinforced
Insulation. Manufacturing follows a series of
constructive requirements such as standardized
drive keys, cords and motors, flow distances
and gap between the energized parts. The
materials used meet safety requirements of
household appliances and similar products by
INMETRO, Ordinance 371. Despite that
double insulation, the safety precautions
described in this manual shall be
followed.
Maintenance and Storage
Double Insulation
42
ENGLISH
2.
Do not use solvents or cleaning fluids to
clean your equipment - use a blunt scraper
to remove grass and dirt.
3.
Do not operate your equipment if any parts
are defective; discard all defective parts and
look for TRAPP nearest Assistance Shop.
4.
Keep all nuts, bolts and screws tight to be
sure your equipment is in safe working
conditions.
5.
Use TRAPP recommended replacement
parts and accessories only.
✔ According to NR12, item 12.135,
"maintenance must only be carried
out by qualified, skilled professionals
or authorized to do so".
Always look for a TRAPP Authorized
Assistance Shop. TRAPP is not
responsible for occasional accidents or
damage due to the use of parts and
accessories that are not original.
Double-insulated equipment do not require
grounding.
Warning:
Double insulation does not replace the
safety precautions that shall be taken
when running the equipment. The
double insulation is an additional safety
feature against accidents that may be
caused by a failure of the equipment
insulation.
Publicidad
Tabla de contenido
