Publicidad
Restoring to the factory settings
1
Put both earphones (L and R) into the charging cradle to charge the earphones
fully.
2
Take the R side earphone out of the charging cradle.
3
While the earphone LED lights (blue) (about 5 seconds), touch and hold the
touch sensor (R) for about 7 seconds.
• The earphone LED will light alternately in blue and red.
4
Release your finger from the touch sensor (R).
5
Touch and hold the touch sensor (R) for about 10 seconds.
• The earphone LED (blue) blinks rapidly, and when the power turns off, the earphone
returns to the factory settings.
6
Do the same Steps 2 to 5 above for the L side earphone.
• To re-pair the earphones with a Bluetooth
name: EAH-AZ60M2 or EAH-AZ40M2) on the device, then pair the earphones with the
®
Bluetooth
device again.
®
device, delete the registered information (device
Publicidad
