Samsung RF260B Serie Manual Del Usuario página 11

INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator. To help promote
better health, the water filter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water pressure }
of 20N125psi (138N862kPa) is required.
If the refrigerator is installed in an area with low
water pressure (below 20psi), you can install
a booster pump to compensate for the low
pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly filled. To do this, press the water
dispenser lever until the water runs from the water
outlet.
[_ ater line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and W' compression nut.
Connecting to the water supply line
1. First, shut off the main water
supply.
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut offvalve.
Cold water line.
Pipe clamp
Shut off valve
3. Connect the water line installation kit to the
shut off valve.
Pipe clamp --
Water line installation kit
Connecting the water supply line to
the refrigerator.
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
Use Copper Tubing Use Plastic Tubing
Y4" copper tubing • W' plastic tubing
Y4" compression nut (1pc) _ Molded end(Bulb)
Ferrule (2pc) • Y4" compression nut (1 pc)
Refrigerator '_,,
_._ Plastic Tubing
Compression _ j_ (Assembled)
As'semi'led )''''_ '_'_" _ Comp .... ion
( ) _t_ Fitting
......... .,_ ........... ,
(Assembled)
i [=1 :' _ Molded
Perrule--4--_ : ! "_ , end(Bulb)
(Not supplied) _ i I_ !
Compression
_Not _Bs)u (plp_e)d)
Coppertubing or Plastic tubing (B)
(Not supplied) (Not supplied)
1. Connect the household water line to the
assembled compression fitting.
4fyou are using copper tubing, slip the
compression nut ( B ) (not supplied) and
ferrule (not supplied) on the copper tubing (not
supplied) as shown.
4fyou are using plastic tubing ( B ), insert the
molded end (Bulb) of the plastic tubing ( B )
into the compression fitting.
sett-_g up 11