Descargar Imprimir esta página

DeWalt DXCM803 Manual De Instrucciones página 22

Compresor eléctrico de aire, transmisión por correa, dos etapas

Publicidad

Idiomas disponibles

Idiomas disponibles

Service and Adjustments
ALL MAINTENANCE AND REPAIR OPERATIONS NOT LISTED
MUST BE PERFORMED BY TRAINED SERVICE TECHNICIAN.
Risk
of
unsafe
automatically when power is on. When servicing, you may be
exposed to voltage sources, compressed air, or moving parts.
Before servicing unit unplug or disconnect electrical supply to
the air compressor, bleed tank of pressure, and allow the air
compressor to cool.
To Replace or Clean Check Valve
1.
Release all air pressure from air tank. See Draining Air Tank in
the Maintenance section.
2.
Set the Auto/Off lever to "Off", unplug the unit, and relieve all
air pressure from the air tank.
3.
Using an adjustable wrench loosen outlet tube nut at air tank
and pump. Carefully move outlet tube away from check valve.
4.
Using an adjustable wrench loosen pressure relief tube nut at
air tank. Carefully move pressure relief tube away from check
valve.
5.
Unscrew the check
valve (turn
counterclockwise)
using a 1-3/16"
open end wrench.
In open
NOTE: the
position
orientation for
nothing is
reassembly.
visible.
6.
Using a
screwdriver,
carefully
operation.
Unit
cycles
Screwdriver
In closed position
disc is visible.
22
push the valve disc up and down. NOTE: The valve
disc should move freely up and down on a spring
which holds the valve disc in the closed position, if not,
the check valve needs to be cleaned or replaced.
7.
Clean or replace the check valve. A solvent, such as paint or
varnish remover can be used to clean the check valve.
8.
Apply sealant to the check valve threads. Reinstall the check
valve (turn clockwise) to proper orientation.
9.
Replace the pressure release tube. Tighten nuts.
10. Replace the outlet tube and tighten nuts.
11. Perform the Break-in Procedure. See Break-in Procedure in
the Operation section.
Additional Service
Disassembly or service of the air compressor beyond what is
covered in this manual is not recommended. If additional service is
required, contact your nearest Authorized Warranty Service Center.
Accessories
Recommended accessories for use with your tool are available for
purchase from your local dealer or authorized service center. If you
need assistance in locating any accessory for your tool, please call
1-888-895-4549 or visit our website www.dewalt.com.
WARNING: The use of any other accessory not recommended
for use with this tool could be hazardous. Use only accessories
rated equal to or higher than the rating of the air compressor.
Service Information
Please have the following information available for all service calls:
Model Number ____________ Serial Number ___________
Date and Place of Purchase ____________________________

Publicidad

loading