Warm House Oslo OWF-1/0303 Manual Del Usuario página 5

Installation

Do not connect the fireplace to the power supply until properly fixed to the wall and the
instructions are carefully read.

Make sure the area to be drilled does not have any hidden electrical wires or water and gas
pipes.

The minimum distances must be observed as shown in the diagrams below.

During installation of the fireplace, avoid any possible damage to concealed cables.

Please be careful when drilling holes.

This fireplace is designed to be permanently fixed to a wall. Choose a wall that is sturdy enough
to hold the weight of the fireplace such as a brick or cinder block wall. If positioning on drywall,
it must be fixed to studs. If you are not sure if the wall is stable enough, then consult a hardware
expert. The wall bracket must be fixed horizontally with the cable routed to the bottom right of
the fireplace.

For optimum viewing of the fuel bed, it is recommended that there be a distance of 2 feet from
the bottom of the fireplace relative to the floor (see figure for recommended fixed dimensions).
35.4 inch
5
5.9 inch
2 feet