Profi Care PC-HL 3116 Manual De Instrucciones página 15

Mode Weekdays
Monday – Friday
Saturday – Sunday
* The appliance runs until the next morning.
1. Press the button repeatedly to select the desired
weekly timer.
2. Confirm your selection with the
3. Individually programmable weekly timer:
When selecting the week timer
shows (Monday).
4. Select the desired weekday (Monday) to (Sunday)
with the or button. Confirm the entry with the
button.
5. Now set the start time with the
6. Confirm your selection with the
7. Set the stop time with the
8. Confirm the entry with the
OK
other day of the week. Otherwise, wait until the appliance
slowly scrolls through the weekdays until . The default
setting is then applied.
Deleting the Set Week Timer
Proceed as follows to delete the previously set week timer:
1. First press the button.
2. To delete the setting, now press the
control lamp 24 / 7 goes out.
Open Window Detection
• The function can only be selected when the appliance is
in the heating function or in the TEMP function.
• The appliance performs a temperature check at regular
intervals and switches off when the temperature dif-
ference from the previous ambient temperature drops
drastically. is shown in the display.
1. Press the button to switch on the function. The control
lamp TEMP starts flashing.
2. Press the button again to switch the function off.
Ending Operation
1. Press the button to switch off the appliance. If the
heating mode was active, the FAN mode is activated for
30 seconds and the air flap is closed. The appliance then
switches to standby mode.
2. Set the mains switch on the right side of the appliance to
the O position.
3. Then pull the mains plug out of the socket.
PC-HL3116_IM
Time
18:00 – 7:00*
0:00 – 23:59
button.
OK
, the display now
OK
or button.
button.
OK
or button.
button if you want to set an-
button. The
C ° °
Overheat Protection
The appliance features an overheat protection mechanism
causing the appliance to switch off automatically in case of
overheating.
1. Set the mains switch on the right side of the appliance
to the O position. Then pull the mains plug out of the
socket.
2. Let the appliance cool down for approx. 10 minutes
before using it again.
- If the overheat protection mechanism causes the appli-
ance to switch off again after a short period, this might in-
dicate a defect. Switch off the appliance and disconnect
it from the mains. Have the appliance checked by your
dealer or our customer service.
Cleaning
WARNING:
• Always unplug the appliance from the mains before
cleaning and wait until the appliance has cooled down.
• Never immerse the appliance in water to clean it. This
may lead to electrical shock or fire.
CAUTION:
• Do not use wire brushes or other abrasive materials.
• Do not use caustic or scouring agents.
• Wipe away dust with a dry cloth.
• Flecks can be removed with a suitably damp cloth.
Dust on the Protective Grille
If dust has collected on the protective grille, this can cause
overheating.
• Remove the dust by careful brushing.
or
• Use the upholstery nozzle of your vacuum cleaner to
remove the dust.
Technical Data
Model:.................................................................. PC-HL 3116
Power supply:.....................................220 – 240 V~, 50 – 60 Hz
Power consumption: ...................................................2000 W
Protection class: ...................................................................
Net weight: ....................................................... approx. 2.4 kg
The right to make technical and design modifications in
the course of continuous product development remains
reserved.
This appliance has been tested according to all applicable,
current CE directives and built according to the latest safety
regulations.
15
29.06.23