HQ FH10 Manual De Uso página 3

STRUCTURE AND PARTS
1. Handle
2. Air outlet
3. ON/OFF switch control
4. Power indicator
5. Thermostat
6. Base
HOW TO OPERATE
1. Take the unit from the box and remove any protective wrapping.
2. Place the heater on a smooth level surface and least 30cm away from any obstacles.
3. Plug your fan heater into a power socket. Make sure your power supply corresponds to the power
indicated on the rating label.
4. To start the heater and get cool air, turn the knob to the "Fan" position. Turn knob to "I" for the
warm air-low power, "II" for hot air-maximum power.
5. Turn the thermostat switch clockwise or anticlockwise to set your desired temperature. The
thermostat switch will automatically keep the room temperature at the desired level.
Note: Do not force knob beyond its normal stop position.
OVERHEATING SAFETY DEVICE
Your heater is fitted with a safety device that switches off the heater in the event of overheating.
Should the heater stop working, turn the heater off and inspect if there is any blockage at the inlet or
outlet. Wait at least 5 minutes for the protection system to reset before attempting to restart the heater.
If the heater fails to operate the safety device, switch the heater off again, and return the heater to your
nearest service center for examination or repair.
CLEANING YOUR FAN HEATER
1. Always disconnect the appliance from the mains power supply before cleaning.
2. Clean the outside of the heater by wiping with damp cloth or a dry cloth.
3. Do not use Benzine or any other detergents/solvents or chemical agents to clean the heater.
Safety precautions:
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
- Designs and specifications are subject to change without notice.
- All logos, brands or brand logos and product names are trademarks or registered trademarks of their
respective holders and are hereby recognised as such.
- This manual was produced with care. However, no rights can be derived. König Electronic can not
accept liability for any errors in this manual or their consequences.
- Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate system for these
products.
To reduce risk of electric shock, this product should ONLY be
opened by an authorised technician when service is required.
Disconnect the product from mains and other equipment if a
problem should occur. Do not expose the product to water or
moisture.
3