Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Note:
1. Make sure the drain hose is not twisted.
2. Secure the hose so it does not fall. After the washing phase, the washing machine will
drain the hot water.
3. Small sinks are not suitable.
4. To make an extension use a hose of the same type and secure the connections with clips.
5. Max. Total length of drain hose: 2.50 m.
Secure the drain hose to prevent scalding when draining hot water.
Electric connection
-
Electrical connections must be carried out by a qualified technician in accordance with
the instructions in the manual and the safety regulations in force.
-
Information on voltage, power consumption and protection requirements can be found
on the inside of the door. The appliance must be connected to the mains power supply via
an earthed socket in accordance with the regulations in force.
The washing machine must be earthed by law. Cecotec shall not be liable for any damage
-
to property or injury to people or animals resulting from failure to comply with the above
instructions.
-
Make sure that the capacity of the socket is powerful enough to power the machine (10
A).
-
Before performing any cleaning or maintenance operations on the appliance, disconnect
it from the mains.
After installation, access to the mains socket or disconnection from the mains must be
-
possible at all times by means of a two-pole switch. Do not operate the machine if it has
been damaged during transport, please inform Cecotec Technical Support.
The replacement of the mains cable must only be carried out by Cecotec's Technical
-
Support Service or by a qualified and authorised electrician.
Minimum dimensions of the space where the washing machine is to be installed:
Width 615 mm.
Height: 855 mm.
Carrying
Never lift the device by grabbing the surface during transport.
1. Disconnect the plug.
2. Close the tap.
3. Disconnect the drain and inlet hoses.
4. Remove the water from the hoses and the device.
5. Place the transport screws.
BOLERO DRESSCODE 120700A
88
Publicidad
