MIRKA 1025 L Instrucciones De Manejo página 50

en
DANGER
Electric shock due to faulty mains connecting lead. Touching a faulty mains connecting
lead can result in serious or even fatal injuries.
• Do not damage the mains power lead (e.g. by driving over it, pulling or crushing it).
• Regularly check whether the power cord is damaged or shows signs of ageing.
• If the electric cable is damaged, it must be replaced by an authorized Mirka distributor
or similar qualified person in order to avoid a hazard.
• In no circumstances should the power supply cord be wrapped around fingers or any
part of the operator.
Hazardous dust
WARNING
Hazardous materials. Vacuuming up hazardous materials can lead to serious or even fatal
injuries. The following materials must not be picked up by the machine:
• hot materials (burning cigarettes, hot ash, etc.)
• flammable, explosive, corrosive liquids (e.g. petrol, solvents, acids, alkalis, etc.)
• flammable, explosive dust (e.g. magnesium or aluminium dust, etc.)
In explosive or inflammable atmosphere
CAUTION
This machine is not suitable for use in explosive or inflammable atmospheres or where such atmospheres are likely to
be produced by the presence of volatile liquid or inflammable gas or vapour
Before start-up (A)
The fleece filter bag is pre-installed in the dust extractor
Ensure that the voltage shown on the rating plate corresponds to the voltage of the local mains power supply It is
recommended that the dust extractor should be connected via a residual current circuit breaker
Inspect power cord regularly to detect signs of damage, e g cracks or ageing If the power cord is damaged, it must be
replaced by a Mirka service center or an electrician to avoid danger before use of the dust extractor is continued Use
only the type of power cord specified in the operating manual
As an extension lead, only use the version specified by the manufacturer or one of a higher quality When using an
extension lead, check the minimum cross-sections of the cable:
Cable length
< 20 m
20–50 m
Only use the dust extractor if it is in undamaged condition Never use the dust extractor without a filter, or if the filter is
damaged It is recommended always to use filter bag for dry applications
When dust extractors are used, the rate at which air is exchanged in the room must be adequate if the exhaust air from
the dust extractor is blown into the room (please observe regulations valid in your country)
50
Mirka® Dust Extractor • 1025 L
Cross section < 16 A
1 5 mm²
2 5 mm²
Cross section < 25 A
2 5 mm²
4 0 mm²