Publicidad
Idiomas disponibles
Idiomas disponibles
How to Use the appliance
Automatic ignition with flame failure safety device
The appliance is fitted with a flame failure safety device on each burner,
which is designed to stop the flow of gas to the burner head in the event
of the flame going out.
To ignite a burner:
Press in the control knob of the burner that you wish to light
and turn it anti-clockwise to the maximum position.
If you keep the control knob depressed, the automatic ignition for
the burner will operate.
You should hold down the control knob for 15 seconds after the
flame on the burner has lit. If after 15s the burner has not lit, stop
operating the device and open the compartment door and/or wait at
least 1 min before attempting a further ignition of the burner. After
this
15-second
continue turning the control knob anti-clockwise until the flame is at
a suitable level. The operating position MUST be at a position
between the maximum and minimum position.
To switch the burner off, turn the control knob fully clockwise to
the gas off position.
In case of power failure, the burners can be lit by carefully using a
match.
interval,
to
regulate
11
the
flame
you
should
V.4
Publicidad
