Tesla BGL202BGE Manual De Instrucciones página 5

Daily cleaning on carpets and hard floors.
Clean on the carpet
INSTRUCTIONS FOR USE
Before using appliance, unwind a sufficient length of cable and insert the plug into the power socket. A yellow mark on the
power cable shows the ideal cable length. Don't expend the cable beyond the red mark.
1. Press the ON/OFF button to switch the appliance on.
2. To rewind the power cable, press the rewind button with one hand and guide the cable with the other hand to ensure
that it does not whip causing damage.
3. Power Control: Spin the On/Off switch (Electronic Power Control) knob to control the suction power of the cleaner.
MAINTENANCE
Emptying the dust compartment subassembly
• Always operate the cleaner with the dust compartment subassembly whole installed.
• If you forget to attach HEPA and filter or attach them in the wrong manner, the dust compartment subassembly may not
rinse.
After removing the flexible tube, hold handle and press the locking button.
Cleaning and changing filter, HEPA and sponge
• Filter and songe for air-inlet should be cleaned at least five a year or when it becomes visible solid.
• Clean HEPA for air-inlet when you find it is filled in.
• HEPA for air-inlet and filter for air-outlet are changeable.
• Always operate the cleaner with filters and sponge installed.Otherwise, reduced suction or motor damage may be result.
• Disconnect from electrical outlet, before cleaning filter.
• Do not use a washing machine to rinse filter.
• Do not use hair drier to dry it.
Cleaning and changing filter, HEPA and sponge for air-inlet
1. After opening the dust-glass cap subassembly, press the lock block of dust cup cover until it is unlocked
2. Remove the seal ring of HEPA
3. Remove HEPA from the bracket.
4. Rinse bracket, filter and sponge in lukewarm water and dry them completely (Sponge and HEPA is rinsed by brush.)
5. Put them back.
Clean on the hard floor
5