Publicidad
Idiomas disponibles
Idiomas disponibles
Product overview
1
Connection OASE Control Aquarium Transformer
2
Connection for device with OASE Control functions from the aquarium-keeping segment.
3
Status LED (→ Operating conditions indicated by the Status LED)
4
Service button (→ Service button functions)
Operating conditions indicated by the Status LED
LED
–
Green
Yellow
Green+ yellow Lit
Red
14
LED status
Description
Off
The Aquarium Controller is switched off.
Lit
A direct connection is established.
Flashing slowly
A connection to a WiFi network is established.
(1× per second)
Lit
The Aquarium Controller is starting.
Flashing slowly
The Aquarium Controller is attempting to establish a connection to
(2 s on, 1 s off)
the router. This can take several minutes.
• If no connection is found, check the WiFi connection. If necessary,
The Aquarium Controller is in firmware update mode.
Green is lit, yellow is
A firmware update is in progress.
flashing
Flashing
An internal error has occurred; recommended procedure:
• Disconnect the power supply, wait for approx. 10 seconds, then re-
• If the error remains active, ...
reduce the distance between the Aquarium Controller and the
router.
establish the power supply.
− use the "OASE Control" app to check for new firmware. If neces-
sary, install new firmware.
− reset the device to its factory settings and restart it. (→ Service
button functions)
− contact the OASE service.
EAC0004
Publicidad
