Firmware Upgrade; Technical Specifications - Fracarro FRPRO 10 Instrucciones De Funcionamiento

To load the configuration into the Profiler by means of the FR PRO software, save the configuration file (".cpr
Ma- extension") onto a USB pen drive and follow the instructions in paragraph "5.2.3 USB MEMORY MENU."
NOTE:
If you want to modify the file name of the configuration after saving it on the PC, please take note that the
name must be no longer than 16 letters ( ".cpr" extension not included) and that special symbols are not
accepted.
After loading the configuration onto the Profiler, we recommend that you perform the self-alignment operation
as specified in paragraph 5.4.
Printing
The Print function allows for the configuration to be printed either in graphics mode or in text mode. To print,
click File and then Print.
The Profiler unit can be upgraded by a PC by means of the RJ45 serial port. To find the last firmware, refer to
the section "Software updating" within the website www.fracarro.com.
F1,
Green LED of the feeder to show that the network is enabled
Green LED that shows that the unit is working properly
Red LED that shows the remote power supply is enabled in the UHF1, UHF2 and UHF3 inputs
16 letters on 2 row display, built-in keypad for programming
USB 2.0 port to load/save configuration file by means of a USB pen drive
Self-leveling of signals levels
Cluster selectivity (dB)
Separation between inputs (dB)
Connectors
Return loss IN/OUT (dB)
TV TEST Output (dB)
Supply voltage (Vac)
Consumption (W)
Operating temperature
Dimensions (mm)
F3.
Technical data is nominal values and refer to an operating temperature of 25° C.
cide
rch
Frequency (MHz)

7. FIRMWARE UPGRADE

8. TECHNICAL SPECIFICATIONS

General features of the FRPROX product
FRPRO 10
UHF1 UHF2
470÷862 470÷862
20dB / 10MHz
≥ 30
75 Ω (Type F)
≥ 10
- 25
220-240 @ 50-60Hz
23 (FRPRO10) – 25 (FRPRO10A) – 32 (FRPRO10S)
-5 to 55 °C
360x225x60
Inputs
UHF3 FM
470÷862 87÷108
49
BIII+DAB AUX
170÷320 47÷862