DeWalt DWE4212 Manual De Instrucciones página 39

is forbidden. Cutting can also be performed by using a
Type 41 wheel and a Type 1 guard.
NoTE: See the Accessories Chart to select the proper guard
/ accessory combination.
Adjusting and Mounting Guard (Fig. C, D)

CAUTION: Turn unit off and unplug the tool before
making any adjustments or removing or installing
attachments or accessories.

CAUTION: BEFORE operating the tool, identify which
guard adjustment option your tool is set to.
adjustment options
For guard adjustment, the guard release lever
one of the alignment holes
a ratcheting feature. Your grinder offers two options for
this adjustment.
one-touch TM : In this position the engaging face is
•
slanted and will ride over to the next alignment hole
when guard is rotated in a clockwise direction (spindle
facing user) but self-locks in the anti-clockwise direction.
Two-touch : In this position the engaging face is
TM
•
straight and squared off. It will NOT ride over to the next
alignment hole unless guard release lever is pressed and
held while simultaneously rotating the guard in either a
clockwise or anti-clockwise direction (spindle facing user).
TM
One-Touch
setting Guard adjustment options
To adjust the guard release lever
adjustment option:
19
1. Remove screw using a T20 bit.
2. Remove the guard release lever taking note of the
spring position. Choose the end of the lever for the
desired adjustment option. One-touch will use the
slanted end of the lever
16
holes on the guard collar. Two-touch will use the
squared end to engage the alignmnet holes
guard collar.
3. Replace the lever, positioning the chosen end under the
14
spring . Ensure the lever is in proper contact with
the spring.
4. Replace screw and torque to 2.0-3.0N-m. Ensure proper
installation with spring return function by depressing
10
guard release lever
10
engages
15
on the guard collar using
TM
Two-Touch
10
for desired
10
to engage the alignment
16
.
Fig. C
14
Mounting Guard (Fig. D)

CAUTION: Prior to mounting guard, ensure the screw,
lever, and spring are fitted correctly before mounting
the guard.
1. With the spindle facing the operator, press and hold the
guard release lever
2. Align the lugs
the gear case.
3. Push the guard down until the guard lugs engage and
rotate them in the groove on the gear case hub. Release
the guard release lever.
4. To position the guard:
one-touch
desired working position. Press and hold the guard
release lever
anti-clockwise direction.
Two-touch
10
lever . Rotate the guard clockwise or anti-clockwise
into the desired working position.
NoTE: The guard body should be positioned between
the spindle and the operator to provide maximum
operator protection.
The guard release lever should snap into one of the
on the
alignment holes
that the guard is secure.
5. To remove the guard, follow steps 1–3 of these
instructions in reverse.
10
.
14
on the guard with the slots
TM : Rotate the guard clockwise into the
10
release lever to rotate the guard in the
TM : Press and hold the guard release
16
on the guard collar. This ensures
ENGlIsh
19
10
15
on
37