Leggett & Platt FLIGHT P Guia Del Usuario página 3

REMOTE CONTROL REQUIRES (3) AAA SIZE BATTERIES. TO CONSERVE BATTERY LIFE, THE TRANSMITTER
TURNS OFF ALL FUNCTIONS WHEN ANY BUTTON IS PRESSED FOR MORE THAN 50 SECONDS.
REMOTE CONTROL PROGRAMMING - 1 REMOTE TO OPERATE 1 BASE
1
Simultaneously press and hold the HEAD
UP and FOOT DOWN buttons on the remote
control until the remote control backlight
flashes, then release both buttons.
UBL
HEAD UP
HEAD
SNORE
HEAD
3
Simultaneously press and hold the HEAD
DOWN and FOOT UP buttons on the remote
control until you hear an audible sound, then
release both buttons.
HEAD DOWN
FLAT
FOOT
PILLOW
FOOT DOWN
MEM
ZGRAV
SET
MASSAGE
FOOT
UBL FLAT
HEAD PILLOW FOOT
SNORE MEM
ZGRAV
SET
HEAD MASSAGE FOOT
NOTE
Unplug the base from the power outlet.
2
Wait 3 minutes, then plug base back
into power outlet. You have 1 minute
to complete programming procedure.
4
Operate the remote control to verify
the base functions correctly.
FOOT UP
NOTE
AN ELECTRICAL SURGE
PROTECTION DEVICE IS
RECOMMENDED (NOT INCLUDED).
3