Publicidad
Idiomas disponibles
Idiomas disponibles
• Never use forspreading
chemicals,
fertilizers,
orany other substances
which m ay c ontain toxic m aterials.
STANDARDS
This product is listed by Underwriters
Laboratories, Inc., in accordance with
UL Standard 1017.
If situations occur which are not covered
in this manual, use care and good judg-
ment.
If you need assistance, contact your
Sears Service Center or call
1-800-235-5878.
Failure to follow all Safety Rules and
Precautions can result in serious injury.
SAVE THESE INSTRUCTIONS
CARTON
CONTENTS
Model 358.799343
• Blower
• Blower Tube
• Nozzle
Examine parts for damage.
Do not use
damaged
parts.
NOTE: If you need assistance
or find
parts missing or damaged,
call
1-800-235-5878.
_WARNING:
If received as-
sembled, ensure your unit is properly
assembled and all fasteners are secure.
ATTACHING
THE BLOWER
TUBE
AND NOZZLE
1. Insert the blower tube into the blow-
er outlet.
2. Twist the blower tube clockwise until it
is firmly seated in the blower outlet.
3. Twist the nozzle into the end of the
blower tube until it is firmly seated.
Make sure the nozzle end points
upward as shown in the following
illustration.
Blower Tube
Nozzle
SELECT
AN EXTENSION
CORD
Use only a 120 A.C. voltage
supply as
shown on nameplate
of the unit to
power your blower.
• To reduce the risk of electrical shock,
this equipment has a polarized plug
(one blade is wider than the other) and
will require the use of a polarized
extension cord. The appliance plug will
fit into a polarized extension cord only
one way. If the plug does not fit fully
into the extension cord, reverse the
plug. If the plug still does not fit, obtain
a correct polarized extension cord.
A polarized extension cord will require
the use of a polarized wall outlet. This
plug will fit into the polarized wall outlet
only one way. If plug does not fit fully
into the wall outlet, reverse the plug. If
it still does not fit, contact a qualified
electrician to install the proper wall
outlet. Do not change the equipment
plug, extension cord receptacle, or
extension cord plug in any way.
The extension
cord used to reach the
power source must be:
• Specifically marked as suitable for out-
door use. The cord must be marked
with the suffix '_#V-A"(in Canada "W").
• Heavy enough to carry current from
the power source the full length of ex-
tension cord to the unit. Otherwise,
loss of power and overheating
can oc-
cur causing damage to unit. Refer to
table for minimum wire gauge recom-
mendations. The cord must be
marked with the proper wire gauge.
(Appropriate extension cords are avail-
able at Sears.) Do not use multiple
cords.
• In good condition. Cord insulation
must be intact with no cracks or
deterioration. Plug connectors
must be
undamaged.
DO NOT use multiple
cords.
MINIMUM WIRE GAUGE
RECOMMENDATIONS
50 FT
100 FT.
16
14
A.WG*
A W.G.*
*American
Wire
Gauge
SECURE EXTENSION
CORD TO UNIT
CAUTION:
Failure to use cord retain-
er could result in damage to the unit,
extension
cord, or both.
5
Publicidad
