Using The Vise Clamp; Long Workpiece Support - skilsaw SPT64MTA Instrucciones De Funcionamiento Y Seguridad

1619PA9299 09-15 SPT64MTA.qxp_SPT64MTA 9/14/15 7:02 AM Page 12

Using the Vise Clamp

Changing Cutting Angle
1. Loosen the vise stop adjustment bolts with the wrench
provided, (Figure 8), DO NOT REMOVE.
2. Align desired angle on vise stop scale with index line in
base, and securely tighten bolts with the wrench
provided.
Maximum Cutting Depth
To obtain maximum cutting depth, position vise stop so
material being cut is approximately centered under wheel,
when wheel is lowered all the way down.
To reposition the vise stop:
1. Loosen and remove vise stop adjustment bolts with the
wrench provided (Figure 8).
2. Move vise stop to desired location holes, install and
securely tighten bolts with the wrench provided.
To release work, turn vise handle to loosen, lift quick
release lever up (Figure 8), and pull screw shaft away from
work.
To lock work, push screw shaft toward work, lower quick
release lever and turn vise handle clockwise to tighten.
FIG. 8
Vise
Handle
Screw
Shaft
Quick Release Lever
Quick Release
Lever
Base
Adjustment
Operation

Long Workpiece Support

Support long workpieces to prevent sagging. Use auxiliary
workpiece support for long workpieces (Figure 9).
FIG. 9
Workpiece
Support
Vise Clamp
Vise Stop
Scale
Vise Stop
Bolts
12.
Cut-Off
End
Additional
Vise Stop
Mounting
Holes
Index
Line