Making A Cut; Recommended Cutting Capacity - skilsaw SPT64MTA Instrucciones De Funcionamiento Y Seguridad

1619PA9299 09-15 SPT64MTA.qxp_SPT64MTA 9/14/15 7:02 AM Page 13
Be aware of the path of the wheel. Make a dry run with the
saw OFF by conducting a simulated cutting cycle, and
observe the projected path of the wheel. Keep hands at
least six (6) inches away from the projected path of the saw
wheel.
1. Properly position workpiece. Make sure workpiece is
clamped firmly against the vise and the vise stop.
2. Activate the switch. Lower the head assembly and make
your cut.
3. Wait until wheel comes to a complete stop before
returning head assembly to the raised position and/or
removing workpiece.
WARNING
Applicable Wheel
Dimensions
Workpiece
Configuration
(Cross-Section)
Maximum Cutting
Capacity (a)
Maximum Wall
Thickness (b)

Making a Cut

Recommended Cutting Capacity

Use of this tool beyond recommended capacities may lead to motor burn-out and possible electric
shock.
5" (127mm)
Operation
14" (355 mm)
4-3/4" (120mm) 4-1/2" (114mm)
1/4"
13.
FIG. 10
a a
b
5-3/8" (136mm)